Introduction
We built this ERP standard heater for one reason: to slip right into industrial machines and get them hot again. Think of it as a halogen infrared tube that packs a serious punch without taking up a lot of room. It’s the direct replacement you reach for when the old heating element gives up and you need something that fits the same tight space and power limits.
What’s Under the Hood
Here’s the quick version: it runs at 400V and 2500W. That combo gives you high heat density without overloading the wiring that’s already in the machine. The tube is 300mm long—a standard size—so it drops into existing reflector cavities and mounts the same way. Small footprint, big radiant surface. In other words, it fits, and it covers the spot you need to heat.
Materials and Build
The halogen element sits inside a quartz tube, which handles fast heating and cooling cycles without flinching. Output stays steady, even when the machine starts and stops often. The outer coating helps spread the heat more evenly and keeps the tube protected from dust, moisture, and other plant-floor grime. And the R7s connector? It’s a no-fuss industrial standard. Secure, low-resistance, and easy to wire. It stays tight even when the machine is vibrating day in and day out.
Where It Shines (and What to Keep in Mind)
On the line—say, in PET blowing and similar processes—this heater is a straight swap for OEM systems. The high watt density means it warms up fast and gives you tight control over temperature, so your cycles stay consistent. One thing to note: it puts out a lot of local heat. Make sure the surrounding machine has enough cooling and airflow. If you need a tough, standardized heater that behaves predictably and doesn’t demand a redesign, this is the one you can count on.