Introduction
We built this portable industrial heater to be one thing: a compact powerhouse for spot heating on the plant floor. It’s a 400V halogen lamp, packing 2500W of heat into a 300mm quartz tube, wired with an R7s connector. The whole point? Drop it right into what you already have. Get intense, localized heat fast, without the headache of rewiring an entire machine.
The Inside Story
Here’s the thing about that 400V, 2500W setup: it’s all about packing a huge punch into a small space. It gets hot—fast. Perfect for those short cycles where timing is everything. And that 300mm tube? It focuses all that energy into a tight zone. You’re heating the exact spot you need, without scorching the parts next door. But, and this is important, that kind of focused heat means you need to make sure your machine has the right clearance and cooling. Keeps everything else from getting cooked along with the target.
What It’s Made Of
That quartz tube is filled with halogen. That’s what keeps the filament temperature steady and the heat output consistent, day after day. Inside, the coating is designed to reflect infrared energy, pushing more of that radiant heat right onto the workpiece. The result is a temperature you can rely on, every single time. Then there’s the R7s connector. It’s a simple push-fit that locks in tight. Makes swapping it out a breeze, so you’re back up and running with minimal downtime.
Where It Shines
This heater is for the spots where you need serious heat, fast, but don’t have much room to work with. Think adhesive curing, plastic forming, pre-heat stations—you name it. Going with 400V also means less current draw compared to lower-voltage heaters of the same wattage. Less strain on your wiring. And that compact 300mm size slips easily into tight, crowded enclosures. For the engineer on the floor, it’s just a straightforward, easy-to-swap heat module that keeps cycles tight and maintenance simple.